Forge Queue: Not able to click and view Details Pane

Kelmat · 2019-09-12T16:03:53.640Z

Been doing a little forging of chisels this morning and ran into an oddity. Not sure if it will ultimately cause a problem but I can’t click to view the forged sapphire chisel I just made. Hopefully it’ll go through and come out the other side as the proper forge but wanted to document it just in case. Should I be worried?

Thanks,

image778×861 250 KB

Mittins · 2019-09-12T16:05:30.886Z

Probably not. Did you try logging off and on?

Kelmat · 2019-09-12T16:12:47.062Z

Yeah. Switched characters, no change. Restarted Steam, same.

vdragon · 2019-09-12T16:13:52.044Z

This was reported previously as shown below:

Missing axe picture in centraforge queue Community Support

[20190728033703_1]

However, I was unable to reproduce this. Do you remember what you were doing up to this point?

Kelmat · 2019-09-12T16:17:35.331Z

Sorry, I tried to search for any similar reports but didn’t see any. Probably just not matching search terms.

I had just finished the 3rd forge in the list as you can see in the picture. The boons on it were Glow 3 and Magnet 3. I completed the forge with setting resin and then immediately went to view my queue.

Mittins · 2019-09-12T16:38:00.788Z

Sorry to have asked the stupid question. Somebody would have if I didn’t.

Vdragon’s report says that it happens because the first inventory slot in the stack is empty. Thank you for asking this, as I have learned something today.

Rumplypigskin · 2019-09-12T17:21:45.854Z

That happened to me… It could be something to do with multiple queued items?

I started also using the skip button a lot… It might be an issue with that perhaps it normally does happen only when I have multiple items in the queue though. But it happens upon the item entering the queue…

Kelmat · 2019-09-12T18:16:38.952Z

@vdragon linked this thread earlier and this post in it seems to have an explanation:

Missing axe picture in centraforge queue Community Support

I am actually able to replicate that [20190804005025_1] It occurs for a smart stack, where the first position is empty [20190804004807_1] [20190804001904_1]

Here is the finished tool, safe and sound. Also, as noted in the above thread by @Combustive it was a smart stack with the first slot open. This thread can close so far as I’m concerned.

image783×748 196 KB

vdragon · 2019-09-13T13:27:10.405Z

Thanks for the update. I still can’t reproduce this, even when there is no tool visible on the top left square of a smart stack. But I’ll add this post to the existing bug report anyway.